Sodium Tetrachloroaurate
SAFETY DATA SHEET
1 PRODUCT AND SUPPLIER IDENTIFICATION
Product Name: Sodium Tetrachloroaurate
Formula: NaAuCl4 · 2H2O
Supplier: ESPI Metals
1050 Benson Way
Ashland, OR 97520
Telephone: 800-638-2581
Fax: 541-488-8313
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Emergency: Infotrac 800-535-5053 (US) or 352-323-3500 (24 hour)
Recommended Uses: Scientific Research
2 HAZARDS IDENTIFICATION
GHS Classification (29 CFR 1910.1200): Skin corrosion/irritation, category 2, Eye damage/irritation, category 2A, Specific target organ toxicity - single exposure, category 3.
GHS Label Elements:
Signal Word: Warning
Hazard Statements: H315 Causes skin irritation, H319 Causes serious eye irritation, H335 May cause respiratory irritation.
Precautionary Statements: P261 Avoid breathing dust or fume, P264 Wash skin thoroughly after handling, P271 Use only outdoors or in a well-ventilated area, P280 Wear protective gloves/protective clothing/eye protection/face protection, P302+P352 IF ON SKIN: wash with plenty of soap and water, P332+P313 IF SKIN irritation occurs: Get medical advice/attention, P305+P351+P338 IF IN EYES: rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing, P337+P313 IF eye irritation persists: Get medical advice/attention, P304+P340 IF INHALED: Remove victim to fresh air and keep comfortable for breathing, P312 Call a POISON CENTER or doctor/physician if you feel unwell, P362+P364 Take off contaminated clothing and wash it before reuse, P403+P233 Store in a well-ventilated place. Keep container tightly closed, P405 Store locked up, P501 Dispose of contents/container in accordance with local, state or federal regulations.
3 COMPOSITION/INFORMATION ON INGREDIENTS
Ingredient: Sodium Tetrachloroaurate (III) Dihydrate
CAS#: 13874-02-7
%: 100
EC#: 239-241-3
Common Names and Synonyms: Sodium tetrachloroaurate (III) hydrate; sodium chloroaurate; sodium gold chloride; gold sodium chloride.
4 FIRST AID MEASURES
General Measures: Remove patient from area of exposure.
INHALATION: Remove to fresh air, keep warm and quiet, give oxygen if breathing is difficult. Seek immediate medical attention.
INGESTION: Rinse mouth with water. Do not induce vomiting. Seek immediate medical attention. Never induce vomiting or give anything by mouth to an unconscious person.
SKIN: Remove contaminated clothing, wash affected area with soap and water. Seek medical attention. Wash contaminated clothing before reusing.
EYES: Flush eyes with lukewarm water, including under upper and lower eyelids, for at least 15 minutes. Seek medical attention.
Most Important Symptoms/Effects, Acute and Delayed: May cause irritation. See section 11 for more information.
Indication of Immediate Medical Attention and Special Treatment: No other information available.
5 FIREFIGHTING MEASURES
Extinguishing Media: Use suitable extinguishing agent for surrounding materials and type of fire.
Unsuitable Extinguishing Media: No information available.
Specific Hazards Arising from the Material: May emit toxic fumes under fire conditions.
Special Protective Equipment and Precautions for Firefighters: Full face, self-contained breathing apparatus and full protective clothing when necessary.
6 ACCIDENTAL RELEASE MEASURES
Personal Precautions, Protective Equipment, and Emergency Procedures: Wear appropriate respiratory and protective equipment specified in section 8. Isolate spill area and provide ventilation. Avoid breathing dust or fume. Avoid contact with skin and eyes. Eliminate all sources of ignition.
Methods and Materials for Containment and Cleaning Up: Sweep or scoop up. Avoid raising dust. Place in properly labeled closed containers. Scrap can be collected for recycling.
Environmental Precautions: Do not allow to enter drains or to be released to the environment.
7 HANDLING AND STORAGE
Precautions for Safe Handling: Handle in an enclosed, controlled process. Avoid exposure to high temperature. Avoid creating dust. Provide adequate ventilation if dusts are created. Avoid breathing dust or fumes. Avoid contact with skin and eyes. Wash thoroughly before eating or smoking. See section 8 for information on personal protection equipment.
Conditions for Safe Storage, Including Any Incompatibilities: Store in a cool, dry area. Store material tightly sealed in properly labeled containers. Do not store together with oxidizing agents. See section 10 for more information on incompatible materials.
8 EXPOSURE CONTROLS AND PERSONAL PROTECTION
Exposure Limits: OSHA/PEL: ACGIH/TLV:
Sodium Tetrachloroaurate No exposure limit established No exposure limit established
Appropriate Engineering Controls: Whenever possible the use of local exhaust ventilation or other engineering controls is the preferred method of controlling exposure to airborne dust and fume to meet established occupational exposure limits. Use good housekeeping and sanitation practices. Do not use tobacco or food in work area. Wash thoroughly before eating or smoking. Do not blow dust off clothing or skin with compressed air.
Individual Protection Measures, Such as Personal Protective Equipment:
Respiratory Protection: Use suitable respirator when dusts or fumes are present.
Eye Protection: Safety goggles
Skin Protection: Wear impermeable gloves for all contact, protective work clothing as necessary.
9 PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
Form: Crystalline powder
Color: Yellow-orange
Odor: Faint chlorine odor
Odor Threshold: Not determined
pH: N/A
Melting Point: 100 oC (decomposes)
Boiling Point: No data
Flash Point: N/A
Evaporation Rate: N/A
Flammability: No data
Upper Flammable Limit: No data
Lower Flammable Limit: No data
Vapor Pressure: No data
Vapor Density: N/A
Relative Density (Specific Gravity): 0.8 g/cc
Solubility in H2O: 150 g/100 ml @ 10 oC
Partition Coefficient (n-octanol/water): Not determined
Autoignition Temperature: No data
Decomposition Temperature: No data
Viscosity: N/A
10 STABILITY AND REACTIVITY
Reactivity: No specific test data available.
Chemical Stability: Stable under recommended storage conditions.
Possibility of Hazardous Reactions: Hazardous polymerization will not occur.
Conditions to Avoid: Extreme heat
Incompatible Materials: Organic solvents, acids, bases, ammonia, zinc.
Hazardous Decomposition Products: Sodium chlorides, sodium oxides, hydrogen chloride.
11 TOXICOLOGICAL INFORMATION
Likely Routes of Exposure: Inhalation, skin and eyes.
Symptoms of Exposure: May be corrosive or irritating to skin and eyes.
Acute and Chronic Effects:
Sodium Compounds: Sodium compounds have variable toxicity. Sodium ion is practically nontoxic. The toxicity of sodium compounds is frequently, though not always, due to the anion involved.
Gold Compounds: Parenteral administration of therapeutic gold salts has been associated with toxic effects including irritation, rashes or blistering to skin and mucous membranes, allergic reactions, and damage to blood, kidneys, liver and lungs. Dermal and pulmonary effects are mainly associated with chrysotherapy and exposure by intramuscular or intravenous route. Generally gold compounds are poorly absorbed when ingested but may cause gastrointestinal symptoms including nausea, vomiting and diarrhea. No studies for inhalation exposure were found.
Chlorides: Chloride toxicity varies widely; sodium chloride has very low toxicity while carbonyl chloride (phosgene) is lethal in small doses. When heated to decomposition or on contact with acids or acid fumes chloride compounds may evolve toxic hydrogen chloride fumes.
Acute Toxicity: No data
Carcinogenicity: NTP: Not identified as carcinogenic IARC: Not identified as carcinogenic
To the best of our knowledge the chemical, physical and toxicological characteristics of the substance are not fully known.
12 ECOLOGICAL INFORMATION
Ecotoxicity: No data
Persistence and Degradability: No data
Bioaccumulative Potential: No data
Mobility in Soil: No data
Other Adverse Effects: Do not allow material to be released to the environment. No further relevant information available.
13 DISPOSAL CONSIDERATIONS
Waste Disposal Method:
Product: Dispose of in accordance with Federal, State and Local regulations.
Packaging: Dispose of in accordance with Federal, State and Local regulations.
14 TRANSPORT INFORMATION
Shipping Regulations: Not regulated
UN Number: N/A
UN Proper Shipping Name: N/A
Transport Hazard Class: N/A
Packing Group: N/A
Marine Pollutant: No
15 REGULATORY INFORMATION
TSCA Listed: No (CAS# 15189-51-2, NaAuCl4 is listed)
DSL Listed: No (CAS# 15189-51-2, NaAuCl4 is listed)
Regulation (EC) No 1272/2008 (CLP): Skin corrosion/irritation, category 2, Eye damage/irritation, category 2A, Specific target organ toxicity - single exposure, category 3.
WHMIS 2015 Classification: Skin corrosion/irritation, category 2, Eye damage/irritation, category 2A, Specific target organ toxicity - single exposure, category 3.
HMIS Ratings: Health: 1 Flammability: 0 Physical: 0
NFPA Ratings: Health: 1 Flammability: 0 Instability: 0
Chemical Safety Assessment: A chemical safety assessment has not been carried out.
16 OTHER INFORMATION
The information contained in this document is based on the state of our knowledge at the time of publication and is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide. ESPI Metals makes no representation, warranty, or guarantee of any kind with respect to the information contained in this document or any use of the product based on this information. ESPI Metals shall not be held liable for any damages resulting from handling or from contact with the above product. Users should satisfy themselves that they have all current data relevant to their particular use.
Prepared by: ESPI Metals
Revised/Reviewed: April 2017