Sodium Hexachloroosmate
MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Manufacturer/Supplier:
ESPI Metals
1050 Benson Way, Ashland, OR 97520
Toll Free (800) 638-2581 * Fax (541) 488-8313
E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Product Name: Sodium Hexachloroosmate IV
Formula: Na2OsCl6
II. HAZARDOUS INGREDIENTS
Hazardous Components: Sodium Hexachloroosmate
Percent (%): 100
AGCIH/TLV: 1.0 mg/m3
III. PHYSICAL DATA
Melting Point: N/A
Specific Gravity: N/A
Solubility in H2O: Slightly soluble
Appearance and Odor: Red/brown crystalline powder.
IV. FIRE AND EXPLOSION HAZARDS DATA
Flash Point: N/A
Flammable Limits: Not flammable
Extinguishing Media: CO2, Foam, dry powder.
Special Firefighting Procedures: Self-contained breathing apparatus.
Unusual Fire and Explosion Hazards: May emit toxic fumes upon decomposition.
V. HEALTH HAZARD INFORMATION
Effects of Over Exposure: Osmium and its compounds are considered to be very toxic. Can Cause temporary night blindness, and respiratory problems.
EMERGENCY AND FIRST AID PROCEDURES: Remove patient from area of exposure to fresh air.
EXTERNAL: Flush with soap and water for 15 minutes.
EYES: Flush with eye bath.
INTERNAL: Contact poison control center/physician.
VI. REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Extreme heat.
Hazardous Decomposition Products: OsO4, Cl
Incompatible Materials: All acids, alkali, organic solvents, Zn, Al, Oxidizers!!!!
Hazardous Polymerization: Will not occur
VII. SPILL OR LEAK PROCEDURES
Steps to Be Taken in Case Material Is Released or Spilled: Sweep up and place in airtight plastic container.
Waste Disposal Method: Ship to precious metal refiner.
VIII. SPECIAL PROTECTION INFORMATION
Respiratory Protection: NIOSH/MSHA approved.
Ventilation: Fume hood
Protective Gloves: Rubber for all contact
Eye Protection: Goggles
Other Protective Equipment: Normal labwear.
IX. SPECIAL PRECAUTIONS
Precautionary Labeling: In compliance with OSHA and NFPA requirements.
Other Precautions: Store in cool dry place, keep tightly sealed when not in use, read MSDS before using.
The above information is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide. ESPI shall not be held liable for any damage resulting from handling or from contact with the above product.
Issued By: S. Dierks
Date: November 1994